如何更换油装载机中的油泵过滤器?

工具：

• 1/4 英寸 Allen wrench
• 13 mm wrench
• Oil filter wrench
• Oil drain pan
• New oil pump filter

步骤：

1. Park the vehicle on a level surface and apply the parking brake.
2. Locate the oil filter. The oil filter is typically located near the engine block or near the rear of the vehicle. It is a black or dark-colored filter.
3. Disconnect the oil drain plug. Use the 13 mm wrench to loosen the oil drain plug and allow the old oil to drain out.
4. Remove the oil drain plug. Use the 13 mm wrench to remove the oil drain plug and allow the old oil to drain out.
5. Loosen the oil filter nuts. Use the 1/4-inch Allen wrench to loosen the oil filter nuts.
6. Remove the oil filter. Use the 1/4-inch Allen wrench to remove the oil filter.
7. Install the new oil filter. Apply a thin coat of new oil on the gasket of the new oil filter. Screw the new oil filter onto the oil filter nuts by hand until snug.
8. Tighten the oil filter nuts. Use the 1/4-inch Allen wrench to tighten the oil filter nuts in a star pattern. Tighten the nuts until snug, but do not overtighten.
9. Replace the oil drain plug. Use the 13 mm wrench to replace the oil drain plug.
10. Fill the engine with new oil. Use the oil filler hole in the engine to fill the engine with new oil.
11. Start the vehicle and check the oil level. Add oil as needed until the oil level reaches the "full" mark on the dipstick.

Tips:

• Use a new oil filter every 15,000 to 20,000 miles.
• If the oil filter is clogged, it can cause a loss of power, rough idling, and increased oil consumption.
• If you are not comfortable changing an oil filter, you can take the vehicle to a mechanic.